Stay informed about the latest developments in cabinet manufacturing, IP rating standards, outdoor enclosure technology, and industrial cabinet solutions.
Official statistics on solar deployment indicate that as of the end of May 2025, the UK had a total of 18.9 GW of solar capacity across 1,803,000 installations. At least 43% of capacity (7,710 MW) came from ground-mounted or standalone solar installations, including the two operational solar farms accredited on Contracts for Difference (CfD).
The UK has entered a new era for solar power with nearly 3,500 solar farms in the planning system, new figures show. Sharp falls in the cost of solar panels over the past decade and rapid increases in the efficiency with which they can convert sunlight to power solar mean it is now the cheapest way to produce electricity in the UK.
The UK government has published a solar roadmap setting out the steps it will take to secure 47 GW deployed capacity by 2030. Image: Nick Fewing, Unsplash The UK government has published a new “Solar Roadmap” policy paper setting out how it plans to achieve 45-47 GW of deployed solar capacity by 2030, from nearly 19 GW as of May 2025.
In 2023, 196,782 new solar projects were added, marking the second-highest annual total for new installations, following the 208,586 installations in 2011. The UK government set an ambitious goal of achieving 45GW-47GW solar generation capacity by 2030, which means the UK needs to triple its solar capacity over the next decade.
People who live at locations measuring 35 degrees should usually select 35-degree roof pitches for optimal performance. Dynamic factors throughout the year, together with sun position, change the effectiveness of the recommended angle. Your location’s latitude is the primary factor in determining the best roof pitch for solar panels.
Namely, 0°, 15°, 20°, 25°, 30°, 35°, 40°, 45°. “Due to the difference in solar elevation angle between summer and winter, the daily power generation (Epvr) of parallel overhead photovoltaic roofs is optimal (307.2 W/m2) in summer, and the Epvr decreases with the increase of tilt angle,” they explained.
Across the continental U.S., the optimal tilt can range from 30-45 degrees. However, the further north you live, the more orientation can affect solar panel efficiency. For example, homeowners in Phoenix, AZ can expect a 7% drop in efficiency for being 20 degrees off optimal.
You can change the slope of solar panels using tilt mounts despite imperfect roofs. The adjustable system configuration on these mounts allows you to select the best possible angle for your location to give you maximum energy generation. Ground-mounted solar systems should be your consideration when your roof does not meet the requirements.
Image: MET Group. IPP MET Group has put a 40M/80MWh BESS in Hungary into commercial operation, deployed using technology from Huawei. The 2-hour battery energy storage system (BESS) is the largest in Hungary, Switzerland-headquartered MET Group said, deployed at its Dunamenti thermal power plant in Százhalombatta, near Budapest.
The new facility supports a growing push to green Hungary’s power grid. Hungary has just switched on its largest battery energy storage system (BESS) to date, stepping up its role in Central Europe’s growing grid-scale energy transition.
MET Group has switched on Hungary’s largest battery, a 40 MW/80 MWh system, at the site of a power station near Budapest. From ESS News Swiss-based energy company MET Group has officially inaugurated Hungary’s largest standalone battery energy storage system (BESS) at its Dunamenti Power Station in Százhalombatta, located close to Budapest.
The new facility boasts a total power output of 40 MW and a storage capacity of 80 MWh. This project significantly expands MET Group’s energy storage portfolio in Hungary. It joins a smaller 4 MW / 8 MWh demonstrator BESS, which utilizes Tesla Megapack 2 batteries and was installed at the same site in 2022.
ADB said it will be one of the first utility-scale renewable energy projects with a battery energy storage system (BESS) component in Uzbekistan. It follows the announcement of the county’s first BESS in May 2024 and the connection of the first phase of a 511 MW solar project in March of this year.
Separately, ACWA Power recently announced financial close on a 200 MW solar plant and 500 MWh BESS near the national capital, Tashkent. Uzbekistan had 253 MW of cumulative installed solar capacity at the end of last year, according to figures from the International Renewable Energy Agency (IRENA).
The ADB is proposing a large scale, solar-plus-battery system in Uzbekistan. According to a listing on ADB’s website, the Samarkand 1 Solar PV and BESS Project will involve the construction of two solar power plants, of 100 MW and 400 MW, a pooling station, 500 MWh BESS, loop-in loop-out transmission lines, and a 70 km overhead transmission line.
ACWA Power plans to build a 500 MW solar plant and a 500 MWh battery energy storage system in Uzbekistan under a project proposed by the Asian Development Bank (ADB). The ADB is proposing a large scale, solar-plus-battery system in Uzbekistan.
Canadian Solar's e-STORAGE will supply 1.8GWh of battery energy storage systems (BESS) for two projects by Aypa Power in the US.
It is a leading manufacturer of solar photovoltaic modules, provider of solar energy and battery energy storage solutions, and developer of utility-scale solar power and battery energy storage projects with a geographically diversified pipeline in various stages of development.
The system has a nominal capacity of 5 MWh and a roundtrip efficiency of up to 95%. E-storage, the battery unit of Chinese-Canadian PV manufacturer Canadian Solar, has launched a new battery solution for utility-scale applications.
Canadian Solar is one of the most bankable companies in the solar and renewable energy industry, having been publicly listed on the NASDAQ since 2006. For additional information about the Company, follow Canadian Solar on LinkedIn or visit About e-STORAGE
Coordinated control structure of wind power and energy storage. Secondly, the controller parameters of energy storage are evaluated according to the frequency regulation requirements of the system. Finally, the evaluation parameters are sent into the additional controllers to provide reliable frequency support.
Based on the induction factor received from the centralized control system, the turbines capture the kinetic energy from the wind and convert it into electrical energy, where the wake efect impacts the downstream wind turbines by reducing wind speed and generating additional turbulence.
At the same time, the coordinated control problem of multiple voltage and reactive power resources was fully considered. By establishing an optimal voltage control model, precise control of the power station voltage was achieved, significantly improving the coordinated control effect of photovoltaic energy storage power stations.
In order to improve the stability of the wind power and energy storage system, the ESSs adopts the control strategy combining V/f and PQ, which can not only ensure the response to the reference value allocated to the upper layer of ESSs, but also improve the stability of the black-start system.
